Troubleshooting guide

39
Reference Manual
00809-0100-4308, Rev BA
Section 3: Installation
December 2014
Installation
3.10 Utilize the device display
If a device display is ordered, it will be shipped attached to the transmitter. The display is
ordered in the transmitter model number, option code M5.
3.10.1 Rotate the device display
To rotate the display in 90-degree increments, do the following:
1. Squeeze the two black tabs on opposite sides of the display. Refer to Figure 3-20.
2. Gently pull out the display.
3. Rotate the display to the desired orientation, and snap the display into place.
Figure 3-20. Device Display
Note
If the device display four-pin connector is inadvertently removed from the interface board,
carefully re-insert the connector before snapping the device display back into place.
3.10.2 Retrofitting
If an existing transmitter with no display (flat electronics cover) is to be retrofitted with a new
display, order spare part kit number 00753-9004-0001(aluminum display kit) or
00753-9004-0004 (stainless steel display kit). These kits contain an extended cover with a
display viewing window, a display board, and a display pin connector. Replace the flat cover with
the extended display and tighten.
A
A. Display Pins
B. Black tabs
C. Display
D. Cover
B C D