Troubleshooting guide

38
Reference Manual
00809-0100-4308, Rev BA
Section 3: Installation
December 2014
Installation
3.8 Install the power module
Note
Use caution when handling the power module, it may be damaged if dropped from heights in
excess of 20 ft (6 m).
1. Install the Black Power Module, SmartPower™ Solutions model number 701PBKKF into
the transmitter.
2. Close the housing cover and tighten to site or safety specifications. Always ensure a
proper seal by tightening the electronics housing covers so that metal touches metal,
but do not over tighten.
Figure 3-18. Power Module Installation
3.9 Position the antenna
The antenna should be positioned vertically, either straight up or straight down, and it should be
approximately 3 ft (1 m) from any large structure, building, or conductive surface to allow for
clear communication to other devices.
Figure 3-19. Antenna Positioned Vertically
1. 2.
Keep cover tight