Troubleshooting guide

165
Reference Manual
00809-0100-4308, Rev BA
Appendix D: Configuration Parameters
December 2014
Configuration Parameters
Wireless - Broadcasting
Device Display
Message Content Which content (HART command) to broadcast for a message.
Message Variables Which variables that are included in the content.
Trigger Mode How message will be triggered.
Trigger Level At which level message will be triggered.
First and Trigger Variable The 1st variable contained within message which also will be
used to trigger a broadcast.
Triggered Update Rate This defines how often the broadcast message is sent to the
gateway after a user defined trigger level threshold has been
crossed. Faster update rates have an impact on the total
communications traffic on the network, and power module
life.
Default Update Rate This defines how often the broadcast message is sent to the
gateway. Faster update rates have an impact on the total
communications traffic on the network, and power module
life.
Display Mode The display can be configured to different display modes:
Disabled, On Demand, or Periodic.
Display Variables As default, the level variable will be displayed. If more than
one variable is configured, the display will toggle between the
values of the chosen variables.
Display Mode Description
Disabled The display is always turned off.
On Demand The display is by default turned off.
Selected variable screens will only
appear in the end of the diagnostic
button screen sequence, refer to
“Diagnostic button screen sequence”
on page 64.
Periodic The display shows selected variable
screens in a periodic sequence. A new
screen will appear on each wireless
update.