Troubleshooting guide

122
Reference Manual
00809-0100-4308, Rev BA
Appendix A: Reference Data
December 2014
Reference Data
Options
Display
M5 Device Display (see page 102)
★
Factory configuration
C1 Factory Configuration (Configuration Data Sheet required with order, available at www.rosemount.com)
★
Certifications
P1 Hydrostatic Testing
★
Q4 Calibration Data Certificate
★
Q8 Material Traceability Certification per EN 10204 3.1
★
Q66 Welding Procedure Qualification Record Documentation
Installation options
LS Long Stud for Flexible Single Lead Probes, 25 cm (10 in.) (for use in tall nozzles)
★
BR Mounting Bracket for 1½-in. NPT Process Connection (see page 135)
Weight and anchoring options for flexible single probes (see page 112 for dimensions)
W1 Small Weight (for narrow tank openings less than 2 in. (50 mm)) (Required for PTFE covered probes)
★
W3 Heavy Weight (for most applications)
★
W4 Chuck (to tie probe end to tank bottom)
★
W2 Short Weight (when measuring close to the probe end)
Weight assembly options for flexible single probes
WU Weight or chuck not mounted on the probe
★
PlantWeb diagnostic Functionality
DA1 HART
®
Diagnostics (see page 103)
★
Centering disc (see page 118 for dimensions and size recommendation)
(4)
S2 2-in. Centering disc
(5)
★
S3 3-in. Centering disc
(5)
★
S4 4-in. Centering disc
(5)
★
P2 2-in. Centering disc PTFE
★
P3 3-in. Centering disc PTFE
★
P4 4-in. Centering disc PTFE
★
S6 6-in. Centering disc
(5)
S8 8-in. Centering disc
(5)
P6 6-in. Centering disc PTFE
P8 8-in. Centering disc PTFE
Assemble / consolidate to chamber (see page 115)
XC Consolidate to Chamber
★
Table A-9. 3308 Series Level and/or Interface Measurements in Liquids Ordering Information
The starred options (★) represent the most common options and should be selected for best delivery. The non-starred offerings
are subject to additional delivery lead time.