Manualshelf

Instruction Manual

ManualsBrandsEmerson ManualsControl ValvesEmerson Fisher Vee-Ball V300
11121314151617181920
Instruction Manual
D101957X012
V150 and V300 Valves
November 2011
15
Figure 8. Index Mark for Actuator Lever Orientation
NOTE:
1. ARROW ON LEVER INDICATES DIRECTION OF ACTUATOR THRUST TO CLOSE VALVE.
5. Installing the pins (key 7):
CAUTION
The ball might be damaged if it is allowed to hit the flange edge or interior of the valve cavity while it is being lowered into
the valve body.
D Lift the valve and place it on the edge of both flanges. Make sure the ball is in its open position, and in the lower half
ofthevalvecavity.Blockthepackingboxsideofthevalvesothedriveshaftishorizontal.
D Insert the pin (key 7) into the ball ear and follower shaft until it is flat with the ball ear surface. (Note: the pin does
not extend the full width of the ball ear.
D Refer to the Packing Replacement procedures and install the packing parts as described in that section. Slightly
tighten the packing nuts (key 20).