Instruction Manual

www.Fisher.com
INMETRO Hazardous Area Approvals
for
Fisherr i2P-100 Electro-PneumaticTransducer
Instruction Manual (D103198X012)
This supplement provides INMETRO Hazardous Area Approval information for the i2P-100 electro‐pneumatic
transducer instruction manual. Use this in conjunction with information provided in the instruction manual
(D103198X012).
INMETRO—National Institute of Metrology, Quality and Technology. INMETRO approval is accepted in Brazil.
Certain nameplates may carry more than one approval, and each approval may have unique installation/wiring
requirements and/or conditions of “safe use”. These special instructions for “safe use” are in addition to, and may
override, the standard installation procedures. Refer to the instruction manual for all other information regarding
i2P-100 electro‐pneumatic transducers.
Note
This information supplements the nameplate markings affixed to the product.
Always refer to the nameplate itself to identify the appropriate certification.
WARNING
Failure to follow these conditions of “safe use” could result in personal injury or property damage from fire or explosion,
and area re‐classification.
Certificate Number: 10IEx0006X
Standards Used for Certification: ABNT NBR IEC 60079-0:2013; ABNT NBR IEC 60079-1:2009;
ABNT NBR IEC 60079-11:2013
Conditions of Safe Use (X):
 For applications of intrinsically safe version in Zone 0 (EPL Ga), considering that the equipment enclosure is
aluminum, precautions must be taken to prevent ignitions caused by impact or friction.
Refer to table 1 for additional approval information and figure 1 for a typical INMETRO approval nameplate.
Instruction Manual Supplement
D103633X012
i2P-100 Transducers
December 2014