Data Sheet

i2P-100 Transducer
D103197X012
Product Bulletin
62.1:i2P-100
July 2014
6
Installation
Refer to figure 5 for location of standard mounting
holes in the housing. See figures 1 and 2 for typical
mounting configurations. Standard mounting
hardware is provided for mounting on the actuator, a
pipestand, or surface mount. Field wiring connections
are made to the terminal block accessible under the
housing cap, via the 1/2 NPT conduit connection.
Dimensions are shown in figures 5, 6, 7, and 8.
Ordering Information
To determine what ordering information is required,
refer to the Specifications table. Carefully review the
description of each specification. Specify the desired
choice whenever there is a selection available. Also,
specify options that are applicable to the application.
Figure 5. Dimensions
58.7
(2.31)
22.3
(0.88)
75.2
(2.96)
55.7
(2.19)
33.3
(1.31)
67.8
(2.67)
75.7
(2.98)
22.9
(0.90)
33.3
(1.31)
33.3
(1.31)
1/4 18 NPT VENT
OR PIPE-A-WAY
CONNECTION
1/4 18 NPT
OUTPUT CONNECTION
67 (2.62) CAP
REMOVAL
CLEARANCE
67 (2.62) CAP
REMOVAL
CLEARANCE
1/4 18 NPT
SUPPLY CONNECTION
1/2 14 NPT
CONDUIT CONNECTION
81.6
(3.21)
74.2
(2.92)
34.7
(1.37)
98.7
(3.89)
mm
(INCH)
GE06439
(sheet 1 of 4)
1/4 18 NPT
OUTPUT CONNECTION
36.3
(1.43)
103.9
(4.09)
103.9
(4.09)