Instruction Manual

Instruction Manual
D103557X012
Configuration
January 2015
35
Table 3‐9. Default Alert and Shutdown Settings
Alert Default Alert Setting Default Shutdown Setting
Travel Sensor Failure Enabled Disabled
Temperature Sensor Failure Enabled Disabled
Minor Loop Sensor Failure Enabled Disabled
Pressure Sensor Failure Enabled Disabled
Drive Current Failure Enabled Disabled
Critical NVM Failure Enabled Disabled
Non-Critical NVM Failure Enabled Disabled
Flash Integrity Failure Enabled Disabled
Reference Voltage Failure Enabled Disabled
SIS Program Flow Failure Enabled Disabled
SIS Hardware Failure Enabled Disabled
Loop Current Validation Enabled Disabled
Drive Signal Out of Range Enabled Not Available
Supply Pressure Low Enabled Not Available
Travel Deviation Enabled Not Available
High Travel Disabled Not Available
Low Travel Disabled Not Available
High-High Travel Disabled Not Available
Low-Low Travel Disabled Not Available
Travel Cutoff High Disabled Not Available
Travel Cutoff Low Disabled Not Available
Integrator Saturated High Disabled Not Available
Integrator Saturated Low Disabled Not Available
Cycle Count High Disabled Not Available
Travel Accumulator High Disabled Not Available
Valve Stuck Disabled Not Available
End Point Pressure Control Deviation Disabled Not Available
Tripped by the LCP Disabled Not Available
SIS Locked in Safety Position Disabled Not Available
LCP Communication Failure Disabled Not Available
Output Circuit Communication Failure Disabled Not Available
Alert Record Not Empty Disabled Not Available
Alert Record Full Disabled Not Available
Instrument Time is Approximate Disabled Not Available
For a detailed explanation of the alerts and the recommended actions, refer to Section 5.