Instruction Manual
DVC6000 SIS
September 2013
4-6
Table 4-3. Conditions for Modifying FIELDVUE DVC6000 SIS Digital Valve Controller Parameters (Continued)
Parameters
In Service Out of Service
Protected Unprotected Protected Unprotected
Alerts
Travel Deviation Alert Enable
Travel Deviation Alert Point
Travel Deviation Time
Travel Alert Hi Hi Enable
Travel Alert Lo Lo Enable
Travel Alert Hi Hi Point
Travel Alert Lo Lo Point
Travel Alert Hi Enable
Travel Alert Lo Enable
Travel Alert Hi Point
Travel Alert Lo Point
Travel Limit / Cutoff Hi Alert Enable
Travel Limit / Cutoff Lo Alert Enable
Travel / Pressure Cutoff Hi
Travel / Pressure Cutoff Lo
- - -
- - -
- - -
- - -
- - -
- - -
Cycle Count Alert Enable
Cycle Counter
Cycle Count Alert Point
Cycle Count / Tvl Accum Deadband
Travel Accumulator Alert Enable
Travel Accumulator
Travel Accumulator Alert Point
Partial Stroke Pressure Limit
Pressure Deviation Alert Enable
Pressure Deviation Alert Point
Pressure Deviation Time
Alert Record Has Entries Enable
Alert Record Full Enable
View Alert Records
(1)
Clear ALL Records
- - -
- - -
- - -
- - -
Failure Group Enable
Valve Group Enable
Miscellaneous Group Enable
Status
Instrument Time Invalid Enable
Instrument Time and Date
Calibration in Progress Enable
Autocalibration in Progress Enable
Diagnostics in Progress Enable
Diagnostic Data Available Enable
Pressure Control Active Enable
Multi-Drop Enable
Integrator Saturated Hi Enable
Integrator Saturated Lo Enable
Integral Limit
Integral Dead Zone
- - -
- - -
- - -
- - -
Instrument
HART Tag
Message
Descriptor
Date
Valve Serial Number
Instrument Serial Number
Polling Address
- - -
- - -
- - -
- - -
- - -
- - -
- - -
Pressure Units
Temperature Units
Analog Input Units
Analog Input Range High
Analog Input Range Low
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
- - -
—indicates parameter may be modified for instrument mode and protection shown.
1. Information only.
−Continued−
4