Instruction Manual

DVC6000 SIS

September 2013

2-24

SAFETY GROUND

LOOP−

LOOP+

EARTH GROUND

TALK+

TALK−

39B3399-B Sheet 2

Figure 2-20. FIELDVUE DVC6000 SIS Digital Valve Controller

Terminal Box

Remote Travel Sensor Connections

The DVC6005 SIS base unit is designed to receive

travel information via a remote sensor. The remote

sensor can be any of the following:

 Emerson Process Management supplied

DVC6015, DVC6025 or DVC6035 feedback unit,

 An under-traveled 10 kOhm potentiometer used

in conjunction with onboard 30 kOhm resistor, or

 A potentiometer used in conjunction with two

fixed resistors (potentiometer travel is the same as

actuator travel).

WARNING

Personal injury or property damage,

caused by wiring failure, can result if

the feedback wiring connecting the

base unit with the remote feedback

unit shares a conduit with any other

power or signal wiring.

Do not place feedback wiring in the

same conduit as other power or

signal wiring.

Note

3-conductor shielded cable, 22 AWG

minimum wire size, is required for

connection between base unit and

feedback unit. Pneumatic tubing

between base unit output connection

and actuator has been tested to 15

meters (50 feet) maximum without

performance degradation.