Instruction Manual

Index
September 2013
Index-5
Parts
Common Parts, 8-4
Feedback Parts, 8-5
Gauges, Tire Valves, & Pipe Plugs, 8-5
I/P Converter Assembly, 8-4
Kits, 8-2
Module Base, 8-4
Ordering, 8-2
Printed Wiring Board Assembly, 8-5
Relay, 8-4
Terminal Box, 8-5
Pause Time, 4-21
Performance Tuner, 3-6, 4-8
Pneumatic Relay
Adjusting, 5-10
Parts List, 8-4
Removing, 7-7
Replacing, 7-7
Polling Address, 4-18
Pressure Connections, 2-18
Pressure Deviation Alert Enable, 4-16
Pressure Deviation Alert Point, 4-16
Pressure Deviation Time, 4-16
Pressure Sensor Calibration, 5-6
Pressure Sensor Shutdown, 4-14
Pressure Set Point, 4-11
Setting manually, 4-11
Pressure Tuning Sets, Gain Values, 4-9
Pressure Units, 4-18
Principle of Operation, DVC6000 SIS, A-2
Printed Wiring Board Assembly
Parts List, 8-5
Removing, 7-6
Replacing, 7-6
Setting DIP Switch, 7-6
Setting DIP Switch, 2-31
Protection, 3-2, 4-4
PST Calibration, 5-12
PST Press Limit
double acting actuators, 4-21
single acting actuators, 4-21
PST Pressure Limit, 4-16
PST Start Pt, 4-11
PST Variables, View/Edit, 4-20
R
Raw Travel Input, Displaying Status, 6-9
Reference Voltage Shutdown, 4-14
Related Documents, 1-7
Relay
Double-Acting, 5-10
Single-Acting Direct, 5-11
Single-Acting Reverse, 5-11
Relay A, 5-10
Relay Adjustment, 5-10
Double-Acting, 5-10
Relay B, 5-11
Relay C, 5-11
Relay Type, 4-19
Remote Travel Sensor Connections, 2-24
Using a 10 kOhm External Potentiometer
as, 2-26
Using a Two-Resistor Series as, 2-26
Using the DVC6015, DVC6025 and
DVC6035 Feedback unit as, 2-25
reset, 4-9
Restart Control Mode, 4-3
Revision Information
DVC6000
Device, 6-9
Hardware, 6-9
HART Universal, 6-9
DVC6000 SIS, Firmware, 6-9
Run Time, 6-9
S
Safety Instrumented System, Installation, 2-31
2-Wire System, 2-32
4-Wire System, 2-31
LCP100 (Local Control Panel) Installation,
2-35
Serial Number
Instrument, 4-18
Valve, 4-18, 4-19
Service Tools, 6-2
Set Point Rate Close, 4-12
Set Point Rate Open, 4-12
Setup Wizard, 3-3
Single-Acting Actuators, Output Connections,
2-20
Index