Instruction Manual

DVC6000 SIS
September 2013
Index-4
L
Lag Time, 4-13
Last AutoCal Status, 4-19
Last Calibration Type, 4-19
LCP100 (Local Control Panel), 2-35
LCP100 Local Control Panel
Electrical Connections, 2-35
Installation, 2-35
Line Conditioner, 2-33
Part Number, 8-6
Locked in Safety Alert, 6-3
Loop Connections, 4 to 20 mA , 2-23
Loop Current, checking, 7-15
Loop Current Validation Enable, 4-14
Loop Schematic
ATEX, B-6, B-7
IECEx, B-9
Loop Schematics
CSA, B-2, B-3
FM, B-4
Low Power Write Alert Enable, 4-13
M
Manual Calibrate Travel, 5-4
Manual Conventions, 1-2
Manual Reset, 6-6
Manufacturer, 4-19
Max Travel Movement, 4-20
Maximum Supply Pressure, 4-19
Message, 4-18
Module Base
Removal, 7-4
Replacing, 7-4
Module Base, Parts List, 8-4
Module Base Maintenance, 7-3
Mounting, 1-6
67CFR, 2-17
DVC6005 base unit, 2-13
Pipestand, 2-13
Wall, 2-13
DVC6010 SIS, 2-6
DVC6015, 2-13
DVC6020 SIS, 2-8
DVC6025, 2-15
DVC6030 SIS, 2-10
DVC6035, 2-16
Mounting Guidelines, 2-6
N
Nameplates
ATEX
Flameproof, B-8
Intrinsic Safety, B-6
Type n, B-8
CSA, B-2, B-3
FM, B-5
IECEx, B-10
No Free Time Shutdown, 4-13
Non-Critical NVM Alert Enable, 4-13
Number of Power Ups, Displaying Status, 6-9
O
Offline/Failed Alert Enable, 4-13
Output Connections, 2-20
Double-Acting Actuators, 2-20
Single-Acting Actuators, 2-20
Output Pressure, Displaying Value, 6-8
Output Signal, 1-4
P
Parameters
conditions for modifying, 4-5
Factory Default, Detailed Setup, 4-2
Partial Stroke Test, 6-4
Configuring
Partial Stroke Pressure Limit, 4-21
Pause Time, 4-21
Stroke Speed, 4-20
initiating, 6-4
375 Field Communicator, 6-6
Auxiliary Terminal, 6-5
Local Control Panel, 6-5
Local Push Button, 6-5
Device (Digital Valve Controller), 6-5
Partial Stroke Test (PST), 6-3
Index