Instruction Manual

Index
September 2013
Index-3
End Point Pressure Deviation, 6-3
Environment Alerts, 4-14
EPPC Saturation Time, 4-11
EPPC Set Point, 4-11
Error Messages, Auto Calibrate Travel, 5-4
F
Factory Settings, Restoring, 5-11
Feedback Connection, 4-20
Firmware Revision, 6-9
Flash ROM Shutdown, 4-13
FM
Hazardous Area Classifications, 1-9
Loop Schematics, B-4
Nameplates, B-5
Special Conditions of Safe Use, 2-4
follower arm extension, 2-10
Free Time, Self Test Failure, enabling to
cause instrument shutdown, 4-13
G
Gauges, Tire Valves, & Pipe Plugs
Parts List, 8-5
Replacing, 7-8
Guided Setup, 3-2
H
Hardware Revision, 6-9
HART Communication, Principle of Operation,
A-2
Hart Tag, 4-18
Device Information, 6-9
Hazardous Area Approvals, 1-5, 2-4
Humidity Limits, 1-5
I
I/P Converter
Parts List, 8-4
Removing, 7-6
Replacing, 7-6
Replacing Filter, 7-5
IEC 61010 Compliance Requirements, 1-5
IEC 61326-1 (Edition 1.1), 1-5
IECEx
Conditions of Certification, 2-5
Hazardous Area Classifications, 1-11
Loop Schematic, B-9
Nameplates, B-10
Independent Linearity, 1-4
Initial Setup, 3-2
Input Characterization, 4-11
Input Range, 4-18
Input Signal
Multi-drop, 1-4
Point-to-Point, 1-4
Installation
2-Wire System, 2-32
4-Wire System, 2-31
LCP100 (Local Control Panel), 2-35
Instrument Clock, Setting, 4-17
Instrument Date and Time, 4-19
Instrument Level, 6-9
Instrument Mode, 3-2, 4-2
Instrument Serial Number, 4-18
Instrument Status, 6-4
Viewing, 6-3
Integral Action, Enable Integral Settings, 4-7
Integral Dead Zone, 4-17
Integral Enable
Pressure Tuning, 4-9
Travel Tuning, 4-7
Integral Gain
Pressure Tuning, 4-9
Travel Tuning, 4-7
Integral Settings, 4-8
Integral Dead Zone, 4-8
Integral Limit, 4-8
Integrator Saturation, 4-17
Internal Temperature, Displaying Value, 6-8
ISA Standard 7.0.01, 2-19
Index