Instruction Manual

Instruction Manual
D100390X012
ED Valve
October 2014
22
Figure 12. PTFE Packing Arrangement for Use in ENVIRO-SEAL Bellows Seal Bonnets
UPPER WIPER
(KEY 12)
MALE ADAPTOR
PACKING RING
FEMALE ADAPTOR
SPACER
(KEY 8)
SPACER (KEY 8)
SPACER (KEY 8)
12B4182-A
12B4185-A SHT 1
12B4182-A SHT 2 12B4185-A SHT 2
A5885 / IL
THRUST
RING (KEY 39)
SPRING
(KEY 8)
THRUST
RING
(KEY 39)
BUSHING
(KEY 13)
PACKING SET
(KEY 6)
9.5 mm
(3/8-INCH) STEM
12.7 mm
(1/2-INCH)
STEM
9.5 mm
(3/8-INCH)
STEM
12.7 mm
(1/2-INCH)
STEM
FOR S31600 (316 SST) PACKING
BOX PARTS
FOR ALL PACKING BOX MATERIALS
EXCEPT S31600
SINGLE ARRANGEMENTS
UPPER WIPER
(KEY 12)
MALE ADAPTOR
PACKING RING
FEMALE ADAPTOR
SPACER (KEY 8)
BUSHING
(KEY 13)
PACKING SET
(KEY 6)
BUSHING
(KEY 13)
SPACER
(KEY 8)
BUSHING
(KEY 13)
THRUST
RING
(KEY 39)
9.5 mm
(3/8-INCH)
STEM
12.7 mm
(1/2-INCH)
STEM, NPS 2 VAL VES
12.7 mm
(1/2-INCH)
STEM,NPS3AND4VALVES
DOUBLE ARRANGEMENTS
12B4183-A
18A0906-C
18A5338-A
A5886 / IL
14. Install the packing flange. Properly lubricate the packing flange stud bolts and the faces of the packing flange nuts.
For graphite packing, tighten the packing flange nuts to the maximum recommended torque shown in table 6. Then,
loosen the packing flange nuts, and retighten them to the recommended minimumtorqueshownintable6.
For other packing types, tighten the packing flange nuts alternately in small equal increments until one of the nuts
reaches the minimum rec ommended torque shown in table 6. Then, tighten the remaining flange nut until the
packing flange is level and at a 90-degree angle to the valve stem.
15. Install the travel indicator parts and stem locknuts; mount the actuator on the valve body according to the
procedure in the appropriate actuator instruction manual.