Quick Start Guide

Quick Start Guide
D103470X012
DLC3020f Digital Level Controller
July 2012
24
Process Fluid
Select the Process Fluid tab (figure 14) to access Process Fluid, Temperature Compensation, and Mode.
MANUAL SETUP
PROCESS FLUID TAB
TEMPERATURE
COMPENSATION
VIEW DENSITY PARAMETERS
CHANGE
PROCESS FLUID
PROCESS FLUID
MODE
CONFIGURE
Figure 14. Configure > Manual Setup > Process Fluid
Note
The instrument software contains density tables for common categories of fluids. Custom tables can be built if needed.
Some fluid categories have wide variations within fluid types. Select the fluid category and then the fluid type.
Input the operating process temperature and the density. The DLC3020f will load the density table that best matches the fluid type
at operating conditions.
Process Fluid
Fluid Name
Density In Use
Change Process Fluid —Select Change Process Fluid to begin the process to properly select the corrections for density
of the fluid that occur at operational temperature.
If Temperature Compensation is selected, the proper density table for use in temperature compensation is selected. If
Temperature Compensation is not needed, enter the operating conditions and name the fluid.