Quick Start Guide

Quick Start Guide
D103470X012
DLC3020f Digital Level Controller
July 2012
22
Note
Table 5 provides the driver rod length of 249 sensors with vertical displacers. If your sensor isn't included in table 5 refer to figure 13
to determine the driver rod length.
Table 5. Driver Rod Length
(1)
Sensor Type
(2)
Driver Rod
mm Inch
249 203 8.01
249B 203 8.01
249BF
(3)
203 8.01
249BP 203 8.01
249C 169 6.64
249CP 169 6.64
249K 267 10.5
249L 229 9.01
249N 267 10.5
249P
(3)
(CL125-CL600)
203 8.01
249P
(3)
(CL900-CL2500)
229 9.01
249V (Special)
(1)(3)
See serial card See serial card
249V (Std)
(3)
343 13.5
249VS 343 13.5
249W 203 8.01
1. Driver rod length is the perpendicular distance between the vertical centerline of the displacer and the horizontal centerline of the torque tube. See figure 13. If you cannot determine the
driver rod length, contact your Emerson Process Management sales office
and provide the serial number of the sensor.
2. This table applies to sensors with vertical displacers only. For sensor types not listed, or sensors with horizontal displacers, contact your Emerson Process Management sales office for the
driver rod length. For other manufacturers' sensors, see the installation instructions for that mounting.
3. 249BF, 249P, and 249V sensors are only available in Europe.