Instruction Manual

Instruction Manual
D103434X012
Configuration
November 2014
31
Process Fluid
Select the Process Fluid tab (figure 4‐6) to access Process Fluid, Temperature Compensation, and Mode.
Figure 4‐6. Configure > Manual Setup > Process Fluid
MANUAL
SETUP
PROCESS FLUIDS TAB
TEMPERATURE
COMPENSATION
VIEW DENSITY PARAMETERS
CHANGE PROCESS FLUID
PROCESS FLUID
MODE
CONFIGURE
Note
The instrument software contains density tables for common categories of fluids. Custom tables can be built if needed.
Some fluid categories have wide variations within fluid types. Select the fluid category and then the fluid type.
Input the operating process temperature and the density. The DLC3020f will load the density table that best matches the fluid
type at operating conditions.
Process Fluid
Fluid Name
Density In Use
Change Process Fluid —Select Change Process Fluid to begin the process to properly select the corrections for density
of the fluid that occur at operational temperature.
If Temperature Compensation is selected, the proper density table for use in temperature compensation is selected. If
Temperature Compensation is not needed, enter the operating conditions and name the fluid.
Temperature Compensation
If Temperature Compensation is selected, provide the following information: