Instruction Manual

Instruction Manual
D103434X012
Blocks
November 2014
168
Table B‐54. Primary Transducer Block Parameter Definitions (Continued)
DescriptionInitial ValueRangeMode
RO /
RW
Index
Number
Label
PARAMETER_NAME
TIME_STAMP 67.3 RO NA NA
SUBCODE 67.4 RO NA NA
VALUE 67.5 RO NA NA
Data Type: Float
Value of parameter at alarm time for single
alarm, 0 for multiple alarms
Advise Priority
ADVISE_PRI
68 RW AUTO 0 to 15 2
Data Type: Uint8
Advise alert priority
Advice Enable
ADVISE_ENABLE
69 RW AUTO
1:
2:
3:
4:
5:
6:
7:
8:
2:
3:
6:
7:
8:
Data Type: BIT_ENUM (4)
Advise alert enable. Enable allows detection of
alert. All alerts can be disabled.
Advise Suppress
ADVISE_MASK
70 RW AUTO
1:
2:
3:
4:
5:
6:
7:
8:
All 0
Data Type: BIT_ENUM (4)
Advise alert mask. MASK controls whether an
alert is reported. If alert is enabled the alert
condition is evaluated and the ACTIVE
parameter is updated reflect if alert is active or
not. If the bit is set reporting is suppressed.
Advise Active
ADVISE_ACTIVE
71 *RO
1:
2:
3:
4:
5:
6:
7:
8:
All 0
Data Type: BIT_ENUM (4)
Advise Alert Status
0 = inactive, 1 = active
Advise Alarm
ADVISE_ALM
72
Data Type: DS‐71
Used to report alerts to host system.
UNACKNOWLEDGED 72.1 RW AUTO
0: Undefined
1: Acknowledged
2: Unacknowledged
0
ALARM_STATE 72.2 RO NA
0: Undefined
1: Clear (reported)
2: Clear (not reported)
3: Active (reported)
4: Active (not reported)
0
TIME_STAMP 72.3 RO NA NA 0
SUBCODE 72.4 RO NA NA 0
VALUE 72.5 RO NA NA 0
Data Type: Float
Value of parameter at alarm time for single
alarm, 0 for multiple alarms
HEALTH_INDEX
73 RO NA 0 to 100 100
Data Type: Uint8
Represents overall health of device. 10% ‐ Failed
Alert is active, 60% ‐ Maintenance Alert is active,
90% ‐ Advisory Alert is active, 100% no alerts are
active.
PWA_SIMULATE 74 *RO AUTO
1: Simulate Off
2: Simulate Enabled
1: Simulation off
Data Type: Enum (1)
When this is set to 2 all the alert ACTIVE
parameters can be written, except for
DETAILED_STATUS. This allows alerts to be
simulated for testing with hosts.
*RW when simulate jumper is jumpered
RAPID_RATE_LIMIT 75 RW AUTO
Lower limit: 1% of
displacer length.
Upper limit: displacer
length.
1.778 cm
The maximum amount of fall/rise in level before
the rapid fall/rise alerts activate per second.
-Continued-