Manualshelf

Instruction Manual

ManualsBrandsEmerson ManualsValve InstrumentationEmerson Fisher DLC3020f Fieldbus Digital Level Controller
121122123124125126127128129130
Instruction Manual
D103434X012
Blocks
November 2014
119
Application Information
The configuration of an AO function block and its associated output channels depends on the specific application. A
typical configuration for the Analog Output involves the following attributes:
PV_SCALE Set the range and engineering units to values that correspond to the operation range. For the
digital level controller, PV_SCALE [11] is typically set between 0 and 100%.
BKCAL_OUT If you are using the CAS_IN [17]
connector wired from another block, wire the BKCAL_OUT [25] attribute to the other block's
BKCAL_IN [27] attribute.
IO_OPTS Set the type of tracking and action upon fault state.
SHED_OPT Set the action to be taken when the set point or output are not updated in a remote mode.
Block Errors
Table B‐26 lists conditions reported in the BLOCK_ERR [6] parameter. Conditions in italics are not applicable for the AO
block and are provided only for your reference.
Table B‐26. BLOCK_ERR Conditions
Condition Number Condition Name and Description
0 Other (NA)
1 Block Configuration Error ‐ CHANNEL and SHED_OPT set to 0
2 Link Configuration Error (NA)
3 Simulate active ‐ Simulation is enabled and the block is using a simulated value in its execution.
4 Local Override ‐ Device in fault state. Actual mode LO.
5
Device Fault State Set ‐ AO block in fault state after FSTATE_TIME because of Bad status or IFS substatus on CAS_IN or Resource
block commanded fault state.
6 Device Needs Maintenance Soon ‐ Indicates a Maintenance PlantWeb Alert condition is active if Block Error Reporting is enabled.
7 Input failure/process variable has Bad status (NA)
8 Output failure ‐ PV has bad status.
9 Memory Failure (NA)
10 Lost Static Data (NA)
11 Lost NV Data (NA)
12 Readback Check Failed (NA)
13 Device Needs Maintenance Now ‐ Indicates Failed PlantWeb Alert condition is active if Block Error Reporting is enabled.
14 Power Up ‐ This condition exists after power up until actual mode is not Out of Service.
15 Out of Service ‐ The block is in Out of Service (OOS) mode.