Data Sheet
D3 Valve
D103269X012
Product Bulletin
51.2:D3
February 2014
4
Actuator Specifications
ELECTRIC ACTUATOR
Material Temperature Capabilities
(1)
Electric Actuator Assembly:
-20 to 70C(-4to158F) ambient
Available Electric Actuator Configurations
easy-Drive Electric On/Off (snap acting)
easy-Drive Electric Positioning (flow or pressure
control)
Power Requirements
12 or 24VDC, minimum 4 amp power supply required
(fuse to 5 amps), 38 mA quiescent
Maximum Current Draw
4amps
Nominal Stroke Speed
(2)
3.9mms(0.15inch/s)at24VDC
2.2 mm/s (0.09 inch/s) at 12VDC
Control Signals
On/Off: Dry contact, Modbus RTU
Positioning: 1-5VDC, 4-20 mA, Modbus RTU
Hazardous Area Approvals
CSA (C/US): ExplosionProof Class I, Division 1,
GroupsCandD,T6,ExdIIAT6,ClassI,Zone1,AExd
IIA T6
ATEX Flameproof - Gas:
II 2 G ,Ex d IIA T6
IECEx Flameproof - Gas: Ex d IIA T6
Enclosure Rating
Type 4X and IP66
Electromagnetic Compatibility
Meets EN 61326-1 (First Edition)
Immunity: Industrial locations per table 2 of EN
61326-1 Standard. Performance is shown in table 2
Emmissions: Class A
ISM Equipment Rating: Group 1, Class A
Conduit Connections
Two 3/4 NPT connections
Option: Reserve Power Unit (RPU)
PNEUMATIC
ACTUATOR
Material Temperature Capabilities
(1)
Pneumatic Actuator Assembly:
-34 to 82C(-30to180F) ambient
Available Pneumatic Actuator Configurations
Spring-to-Open
Spring-to-Close
Maximum Actuator Casing Pressure
(1)
3.4 bar (50 psig)
Actuator Diaphragm Effective Area
329 cm
2
(51 square inches)
Actuator Pressure Connections
1/4 NPT internal
1. The pressure or temperature limits in the referenced tables and any applicable ASME code limitations should not be exceeded.
2. 10% variation can be expected, based on temperature and pressure of application.