Data Sheet
www.Fisher.com
Fisherr 656 Diaphragm Actuator
The Fisher 656 actuator is a bracket-mounted,
direct-acting, diaphragm actuator for either throttling
or on-off service. Principal applications include
operation of butterfly valves and built-in turbine
valves, louvers, dampers, and other similar equipment.
Features
Mounting Versatility–Four tapped holes in the
actuator base permit either bracket or plate
mounting.
Long Actuator Travel–Deep casings provide up to
105 mm (4.125 inches) of maximum travel with a
size 60 actuator.
Application Versatility–Wide spring selection is
available for nearly any control application. Spring
selection procedures are quick and accurate.
Severe Service Capability–Rugged yoke and casings
provide stability and corrosion resistant protection.
Installation
The actuator may be installed in any position.
Dimensions are shown in figure 1.
W1996-2
Fisher 656 Actuator
TRAVEL STOP
ADJUSTING SCREW
SPRING SEAT
BEARING
BEARING SEAT
YOKE
TYPICAL CONSTRUCTION
W0454-1
656 Actuator
D100086X012
Product Bulletin
61.1:656
February 2013




