User`s guide

FEATURES OF THE MX SERVO DRIVE
• MX amplifiers can be connected directly to three phase line power.
• Customizing adjustments to control parameters can be performed and stored in the removable display-
keypad, or serially through the full duplex RS485 serial link.
• Display-keypad module can be transferred, complete with stored personality data, to another amplifier.
• MXP user interactive set up program to speed start up, diagnostics and guarantee correct documentation.
• Provisions for a back-up supply to maintain encoder signals during main power shut-down are available.
• Control circuits are optically isolated from the power circuit.
• Microprocessor digital control of the control inputs and outputs.
• Integrated power supply, shunt circuit, heat sink (and fan as needed).
• The power stage is protected against short circuits, overcurrent, overvoltage, and excessive temperature rise.
• Immediate recall of last-stored or factory default parameter settings. This feature is a considerable advantage
during start-up and commissioning.
• Simulated A/ B/ Z encoder signals with selectable resolution are provided.
• Limit switch inputs, stop-hold, and shaft-orientation functions are available.
• Accel and decel ramps are totally programmable and engage/disengageable.
• Diagnosis is facilitated by fault codes displayed at the keypad and by the MXP program.
• Last-fault function is stored in non-volatile memory for interrogation so it can be recalled even after a power
down may have reset the fault.
• Designed with physical separation between the power connections and control wiring.
• Inrush current limiting circuit to prevent excessive inrush current at power-on.
1
Specifications
1.1 Amplifier Specifications
Table 1.A — Output Power & Losses
units
MX Series Amplifiers
MX-280 MX-440 MX-850 MX-1300 MX-1600
Motor rating kW 1.4 2.2 4.2 6.0 7.5
Input power kVA 4.0 5.8 9.8 9.4 10.8
Input current Amps 5.5 8.0 13.6 13.1 15.0
Max cont. output current Amps 2.8 4.4 8.5 13.0 16.0
Current over-load for 2.9 sec. Amps 5.6 8.8 17.0 26.0 32.0
Heat loss at cont. rating Watts 70 110 210 300 375
Input voltage Three phase 380 VAC -10% to 460 VAC +10% 50/60 Hz
Input power supply voltage