Brochures and Data Sheets

Features
 <1 nanosecond response time
 Solid-state silicon breakover technology
 Low capacitance
 Over-current protection
 UL 497A listed
 Line-to-line protection
 Line-to-ground protection
 Polyswitch resettable fuses — PTCs
 5 year warranty
Operating Voltage 43, 52, 220, & 220 VDC
Clamping Voltage 50, 60, 270, & 270 VDC
Operating Current 0.15 A
Peak Surge Current 160 A
(10 x 1000 µs T & R to Ground)
Frequency Range 0 to 20 MHz
Insertion Loss < 0.1 dB at 20 MHz
SPD Technology Silicon Avalanche Diode
w/ Series PTC
Connection Type Terminal block
with compression lugs IN /
RJ connector OUT
Operating Temperature -40°C to +85°C
Dimensions (Inches) 1H x 2W x 2L
Weight 2 oz
Certifications UL 497A, CUL
Ordering Information
Digital Phone FAS-TEL-060T
Analog Phone/Fax/Modem/
DSL FAS-TEL-200T
Alarm System Phone FAS-31XT
General Technical Specifications
Installation
Edco FAS-TEL and FAS-31XT
RJ11/RJ31X Telephone Protection
The Edco FAS-TEL and Edco FAS-31XT are single pair telephone or data line
protectors that implement advanced two-stage hybrid design. These units
address over-voltage transients with silicon breakover devices, while sneak
and fault currents are mitigated with PTC technology which consists of solid
state resettable fuses.
The Edco FAS-31XT replaces the RJ31X jack with a protected version. Four
screw terminals are provided to wire the protector in the same manner as a
standard RJ31X jack.
The Edco FAS-TEL is nearly identical to the Edco FAS-31XT except with out
the shorting bars. Two screw terminals are provided to connect Telco Line to
protector. Protected equipment such as modems are plu
gged into female
modular jack on the Edco FAS-TEL.
31
Data/Signal Line Protection