Brochures and Data Sheets

Filtering/Line Conditioning
9
Islatrol
™
IC+/LRIC+ Series
Active Tracking Filter
™
120 VAC Models with barrier strip at input and output/with wire leads at input and output (WL)
Rated Case Mounting Flange
Output Dimensions (In) Dimensions (In) Screw Weight
Model (Amps) A x B x C D x E x F x G Size (lbs)
IC+102 / IC+102WL 2.5 4 x 2.88 x 1.81 4.38 x 2.12 x 5.31 x 0.19 #6 1.0
IC+105 / IC+105WL 5.0 4 x 2.88 x 1.81 4.38 x 2.12 x 5.31 x 0.19 #6 1.3
IC+107 / IC+107WL 7.5 4.75 x 4.75 x 2.35 5.25 x 3.50 x 6.25 x 0.19 #6 2.0
IC+115 / IC+115WL 15 6.25 x 4.75 x 2.35 6.75 x 3.50 x 7.75 x 0.19 #8 3.5
IC+130 / IC+130WL 30 7.75 x 4.75 x 2.35 8.25 x 3.50 x 9.00 x 0.19 #8 6.0
120 VAC Models with 5 foot line cord and single NEMA 5-15 receptacle
Rated Case Mounting Flange
Output Dimensions (In) Dimensions (In) Screw Weight
Model (Amps) A x B x C D x E x F x G Size (lbs)
LRIC+102 2.5 4.5 x 3.0 x 1.88 N/A N/A 1.3
LRIC+105 5.0 4.5 x 4.5 x 2.38 N/A N/A 2.0
LRIC+107 7.5 6.0 x 4.5 x 2.38 N/A N/A 2.3
LRIC+115 15 7.5 x 4.5 x 2.38 N/A N/A 4.0
240 VAC Models with barrier strip at input and output/with wire leads at input and output (WL)
Rated Case Mounting Flange
Output Dimensions (In) Dimensions (In) Screw Weight
Model (Amps) A x B x C D x E x F x G Size (lbs)
IC+202 / IC+202WL 2.5 4 x 2.88 x 1.81 4.38 x 2.12 x 5.31 x 0.19 #6 1.3
IC+205 / IC+205WL 5.0 4.75 x 4.75 x 2.35 5.25 x 3.50 x 6.25 x 0.19 #6 2.0
IC+207 / IC+207WL 7.5 6.25 x 4.75 x 2.35 6.75 x 3.50 x 7.75 x 0.19 #8 3.3
IC+215 / IC+215WL 15 7.75 x 4.75 x 2.35 8.25 x 3.50 x 9.00 x 0.19 #8 5.8
IC+230 / IC+230WL 30 7.75 x 4.75 x 2.35 8.25 x 3.50 x 9.00 x 0.19 #8 6.0
Ordering Information
Dimensional Diagram
F
B
C
G
A
D
E
MOUNTING
DIMENSIONS
Islatrol
™
Active Tracking Filters
™
carry a 10 year warranty
F
B
C
G
A
D
E
MOUNTING
DIMENSIONS
Features
■ <1 nanosecond response time
■ Solid-state resettable fuses-PTCs
■ Silicon breakover technology
■ Low capacitance
■ Line-to-line protection
■ Tip and ring to ground protection
■ CAN/CSA C22.2, No. 226-92 Compliant
■ UL 497A listed
■ 4 pair protection
■ 5 year warranty
Edco
™
RJA-RJD Series
RJ-45 Telephone/Data
The Edco
™
RJA and Edco
™
RJD Series are four pair telephone/data line
protectors that implement advanced two stage hybrid design. These units
address over-voltage transients with silicon breakover devices, while sneak
and fault currents are mitigated with PTC technology, which consists of solid
state resettable fuses.
The Edco
™
RJA and Edco
™
RJD Series incorporate RJ-45 female jacks in and out.
The Edco
™
RJA voltage clamp is set for C.O. Trunks and Analog Telephone
Extensions (with ring in voltage), and the Edco
™
RJD voltage clamp is set for
Digital Extensions (no ring in voltage).
Operating Voltage 48, 220 VDC
Clamping Voltage 55, 280 VDC
Operating Current 0.15 A
Peak Surge Current 200 A (10 x 1000 µs)
Frequency Range 0 to 50 MHz
Insertion Loss < 0.1 dB at 50 MHz
SPD Technology Silicon Breakover
Devices w/Series PTC
Connection Type RJ-45 Jacks
Operating Temperature -40°C to +85°C
Dimensions (Inches) 1.0H x 2.5W x 4.25L
Weight 3 oz
Certifications UL 497A, CUL,
Analog Phone RJA-45
Digital Phone RJD-45
General Technical Specifications
Ordering Information
Installation
The Edco
™
RJA and Edco
™
RJD Series are intended
for indoor use only
and shall be employed
on the equipment side of
a listed primary
telephone protector.
Data/Signal Line Protection
16