Brochures and Data Sheets

2.125"
[53.98]
2.4"
[60.96]
Unprotected Pair 2
Unprotected Pair 1
Protected Pair 2
Protected Pair 1
Keying Pin
Even TerminalsOdd Terminals
Field Side
Electronics Side
9
7
5
3
1
10
8
6
4
2
1.0”
[25.40]
{
}
}
{
PCB1B-WKEY
Installation Instructions
Terminal Assignments
Emerson Network Power Contact information
Surge Protection
100 Emerson Parkway
Binghamton, NY 13905
T: [phone]
T: [phone]
F: [phone]
E: [e-mail]
IO-50117 12/14 Rev. 4 Printed in USA
www.EmersonNetworkPower.com/Surge
While every precaution has been taken to ensure accuracy and completeness herein, Emerson Network Power Surge Protection assumes no responsibility, and disclaims all liability, for damages
resulting from use of this information or for any errors or omissions. Specications are subject to change without notice.
Emerson Network Power, the Emerson Network Power logo and Edco are trademarks
and service marks of Emerson Electric Co. ©2014 Emerson Electric Co.
• Connect ground terminals, positions 1 or 10 (internally
tied together) to Building Approved Ground. (See Edco
Tech Bulletin #2015) NOT intended for shield termination.
Install ground in accordance with all applicable codes.
• Edco PCB1B-WKEY accommodates 26 to 10 AWG wire.
• Disconnect telephone line at the network interface before
installing this secondary device.
• This product is intended for indoor use only.
Seulement le personnel qualié doit installer
ou maintenir ce systéme. Des précautions
de sécurité en électricité doivent être suivis
lors de l’installation ou de la maintenance
de cet equipement. Pour eviter tout risque
de choc électrique, débranchez et verouiller
toutes les sources d’alimentation de cet
equipement avant de.
Only qualied personnel should install or
service this system. Electrical safety pre-
cautions must be followed when installing
or servicing this equipment. To prevent risk
of electrical shock, turn off and lock out all
power sources to the unit before making
electrical connections or servicing.
DANGER!
V