User's Manual

Installation

3.8 Side Panels—Remove and Replace

Knurr DCM side panels are simple to remove and replace, making it easier to install equipment.

Panel removal also eases maintenance and replacing equipment.

3.8.1 Remove a Panel

Side panels are attached to the Knurr DCM with 10 quarter-turn plastic retainers. The top of the side

panel has a lip that hangs on the top of the cabinet.

To remove a panel, use a large, flat-blade screwdriver to turn each plastic retainers one-fourth of a

turn or 90 degrees counterclockwise. Lift the panel up and away from the rack. Set it aside.

3.8.2 Replace a Side Panel

1. Hang the side panel on the lip at the top of the Knurr DCM frame.

2. Use a large, flat-blade screwdriver to turn each of the 10 panel retainers clockwise one-fourth of a

turn or 90 degrees.

Table 4 Optional side/partition panel sizes and part numbers

Height, mm Depth, mm

Part Numbers

Side Panels Partition Panels

1200

1000 538521G1L 538521G1L

1100 538521G2L 538521G2L

1200 538521G3L 538521G3L

2000

1000 538521G4L 538521G4L

1100 538521G5L 538521G5L

1200 538521G6L 538521G6L

2100

1000 538521G7L 538521G7L

1100 538521G8L 538521G8L

1200 538521G9L 538521G9L

NOTE

Spinning the plastic quarter-turn retainers more than 90 degrees could damage the retainers.