User's Manual

Installation

3.0 INSTALLATION

3.1 Inspection

Upon receiving a DCF Optimized Rack System, examine the packaging for any signs of mishandling

or damage. If any damage is noted, notify your local Emerson

representative and your carrier

immediately.

Figure 3 DCF Optimized Rack System as shipped

3.2 Required Setup equipment

Each DCF Optimized Rack System ships with all the tools necessary to adjust supplied components.

The tool kit contains the following tools:

• cagenut tool

• 13/14mm wrench

• combination T30 Torx L-key with Phillips head

The following tools are required to set up a DCF Optimized Rack System:

• pallet jack or forklift

• utility knife or scissors

• 14mm socket and rachet or 14mm wrench

Tilt Indicator shows whether

the unit was been tilted beyond

the allowable limit or

mishandled during shipping

Anchor Brackets secure DCF

to shipping pallet; one bracket

in front and one in rear of rack

(packaging removed)

Bolts shown below.

Shrink wrap secures corrugated

corner protectors to the DCF

cabinet and shields the unit

from contact damage

Corrugated Corner

Protectors at each

corner

Part Number and

Serial Number