User's Manual

Installation
10
Figure 9 Alternate door hinge position and grounding wire location
3.4.4 Side Panels
The DCF uses dual split side panels fashioned from sheet metal. The lower panel hangs on a frame
member and the upper panel hangs on the rack frame. Each panel is secured with a lock. The
arrangement makes the panels simple to remove and replace, making it easier to install equipment.
Panel removal also eases maintenance and replacing equipment.
Figure 10 Side panel installation
Remove a Panel
To remove a panel, insert the key in the side panel lock and turn it clockwise to unlock it. Lift the
panel up and away from the rack. Set it aside. Repeat for other panels being removed.
Replace a Side Panel
To install the Side Panel:
1. Insert the bottom panel into cutouts.
2. Move the top of the panel toward the rack.
3. Turn the key counterclockwise to lock the panel in place.
4. Repeat Steps 1 through 3 for other panels being replaced.
Hinge Location when
Reversing Door
Ground Wire Bolt Hole and Symbol
Side Panel Lock
Outside
Side Panel Lock
Inside