User's Manual

Installation

3.4.3 Door—Remove and Reverse

DCF doors are removable for convenience when installing or maintaining equipment. The DCF front

door is also reversible, so the single-door may be opened in a more convenient direction if the rack is

near a wall or other equipment.

Doors are supported by two hinges and held in place by gravity. They can be lifted off and reinstalled

without tools (see Figure 8).

Figure 8 Door hinge removal

Reverse the Door

1. Lift the door off the DCF.

2. Loosen and remove screws from both the top and bottom hinges.

3. Remove the hinges and place them on the opposite side of the frame in the slots provided.

4. Reinsert and tighten the screws.

5. Remove the hardware from the door catch and install the catch on the opposite side of the frame.

6. Flip the door.

The hinge pin assemblies will now be at bottom of the hinge pin attachment point.

7. Remove the hardware, flip the hinge pin and reinsert it in the hinge pin attachment point.

8. Reattach the hinge pin with hardware.

9. Hang the door on the newly positioned hinges.

NOTE

Doors are easier to remove if they are open at a 90° angle to the DCF cabinet.

NOTE

The door handle cannot be reversed.

Door Hinge

Torx head screws

hold the hinge pin

assembly to the

DCF frame

Door Hinge

Door

Frame

Torx Head screws

fit here when the

door is flipped to

change the swing

direction