Manualshelf

User's Manual

ManualsBrandsEmerson ManualsRacks and Integrated SolutionsEmerson DCF Optimized Racks
12345678910
Installation
6
3.3 Unloading the DCF Optimized Rack System
Before unloading a DCF Optimized Rack System, note the weight of the model (see 5.0 -
Specifications. Use at least two people when moving the unit.
1. Using a pallet jack or forklift, move the DCF Optimized Rack System on its pallet to the
installation location.
2. Cut the shrink wrap and remove all packaging.
3. Use a 14mm socket or a 14mm wrench to remove the lag bolts securing each shipping bracket to
the shipping pallet. There are two brackets, one in the front and one at the rear of the rack. Each
bracket is secured by four bolts (see Figure 4).
Shipping bracket can also be used as an anchor bracket once unit is at final resting place. Leave
the shipping brackets attached if they will be used to secure the rack to the floor.
4. Use a pallet jack or forklift to raise the DCF Optimized Rack System off the shipping pallet.
5. Slide the shipping pallet out from under the rack.
The DCF Optimized Rack System may be positioned for installation either with the forklift, by two or
more people carrying it or by rolling the rack on its casters.
If the casters are to be used to move the rack, the leveling feet must be raised. Position the rack and
either lower the leveling feet or bolt the rack to the floor with the shipping/anchoring brackets.
Figure 4 Removing rack from shipping pallet
3.4 Equipment Layout, Repositioning, Removal and Installation
To keep the unit’s center of gravity as low as possible, install equipment from the bottom up, starting
with the heavier units. Leave any unused space at the top of the rack.
!
CAUTION
After equipment is installed, the DCF Optimized Rack System may have a high center of
gravity. Avoid tipping the unit when it is being moved.
DCF rack will rest on casters when
removing the shipping/bolt-down bracket.
... to free the shipping bracket
from the pallet.
Remove lag bolts from brackets
on front and rear of the rack...
Shipping/Anchor Bracket
Leave brackets
bolted to the rack
if they will be used
to secure the rack
to the floor.