Technical data

Guide Specifications—For Liebert DataMate 1.5- to 3-Ton (5 to 10.5kW)

GUIDE SPECIFICATIONS—FOR LIEBERT DATAMATE 1.5- TO 3-TON (5 TO 10.5KW)

1.0 G

ENERAL

1.1 Summary

These specifications describe requirements for an environmental control system. The system shall be

designed to maintain temperature and relative humidity conditions within the room.

The manufacturer shall design and furnish all equipment to be fully compatible with heat dissipation

requirements of the site.

System shall be supplied with CSA Certification to the harmonized U.S. and Canadian product safety

standard CSA C22.2 No 236/UL 1995 for “Heating and Cooling Equipment” and marked with the CSA

c-us logo (60 Hz only).

1.2 Design Requirements

The environmental control system shall be a Liebert DataMate factory assembled unit. The refrigera-

tion system shall be split, with the compressor located in a remote or close-coupled condensing unit.

The evaporator section shall be specifically designed for floor or wall-mounted installation and ser-

viceable from the front of the system. Condensing units shall be designed for outdoor or indoor mount-

ing, below the raised floor, above-dropped-ceiling, or in room installation. Refer to Guide

Specifications Section 2.3, Standard Features/Individual Systems.

Each system shall be capable of delivering ______ CFM. The circulating-air fan shall be two-speed for

precise dehumidification control. The fan motor(s) shall total ______hp (kW) . The system shall be

designed for blow-through air arrangement.

The system shall have a total cooling capacity of ______ Btu/hr (kW), and a sensible cooling capacity of

_____ Btu/hr (kW). based on the entering air condition of ____ °F (°C) dry bulb, and ____ °F (°C) wet

bulb. These units are to be supplied with ____ Volt, ____ PH, ____ HZ power supply.

1.3 Submittals

Submittals shall be provided with the proposal and shall include: Single-Line Diagrams; Dimen-

sional, Electrical, and Capacity data: Piping and Electrical Connection Drawings.

1.4 Quality Assurance

The specified system shall be factory tested before shipment. Testing shall include, but shall not be

limited to: Quality Control Checks, “HiPot” Test (two times rated voltage plus 1000 volts, per NRTL

agency requirements), and Metering Calibration Tests. The system shall be designed and manufac-

tured according to world class quality standards. The manufacturer shall be ISO 9001 certified.

2.0 PRODUCT

2.1 Standard Features/All Systems

2.1.1 Evaporator Cabinet and Frame Construction

The cabinet and chassis shall be constructed of heavy gauge, painted furniture steel. The cabinet

shall be designed for easy installation and service access from the front only.

2.1.2 Air Distribution

The air distribution system shall be constructed with a quiet, direct-drive fan assembly equipped with

multiple double-inlet blowers, self-aligning sleeve bearings, and lifetime lubrication. Fan motor(s)

shall be permanent-split capacitor, high efficiency type, equipped with two speeds for air flow modula-

tion. Dehumidification shall utilize the lower fan speed.

Air filter shall be a cleanable polypropylene monofilament type over expanded aluminum with alumi-

num frame. It shall be easily removable from the front of the system by means of quarter-turn fasten-

ers and shall not require system shutdown for service.