Technical data

ManualsBrandsEmerson ManualsAir ConditionerDataMate 3000 Series

Chapter 5 Microprocessor Control 17

DataMate 3000 Series Air Conditioner Technical Manual

1. Use Up/Down buttons to move the cursor to Teamwork in the System Setup menu, and press Enter to display the

Teamwork sub-menu, as shown in Figure 5-26. Use Up/Down buttons to move the cursor to Cntl Board, and press

Enter to set the control board number for communication with other control boards. It can be set from 0 to 15, and the

default value is 0. Use Up/Down buttons to move the cursor to Unit No, and press Enter to set the unit number. It can

be set from 0 to 15, and the default value is 0.

Cntl Board

Unit NO

Figure 5-26 Teamwork sub-menu

2. Use Up/Down buttons to move the cursor to Start Delay in the System Setup menu, and press Enter to display the

sub-menu, as shown in Figure 5-27. The default values and the setting ranges of the delays in Figure 5-27 are listed in

Table 5-1.

Cold Start

Hot Start

Main Fan

Cp Start

180s

10s

30s

90s

Cp MinOn

Cp MinOff

LP Switch

180s

Figure 5-27 Start Delay sub-menu

3. Press Up/Down buttons to move the cursor to C/F Degrees in the System Setup menu, and press Enter to set the

displayed temperature unit to Celsius (°C) or Fahrenheit (°F). The default unit is Celsius scale.

4. Use Up/Down buttons to move the cursor to Hum Control in the System Setup menu and press Enter to set the

humidity control method to absolute humidity control or relative humidity control. The default method is relative

humidity control.

5. Use Up/Down buttons to move the cursor to Beeper in the System Setup menu, and press Enter to set the beeper to

ON or OFF. The default is ON.

6. Use Up/Down buttons to move the cursor to Backlight in the System Setup menu, and press Enter to set the

backlight to ON or OFF. The default setting is ON.

7. Use Up/Down buttons to move the cursor to Contrast in the System Setup menu, and press Enter to set the contrast

of the LCD. The setting range is from 28% to 38%, and the default setting is 30%.

5.9.2 Select Options

The optional function settings will not be lost when power fails. Select Options from the System Menu to display the

functions listed in Figure 5-28.

Heat

Hum

NewFlow

Standby

OFF

Figure 5-28 Select Options menu

1. Use Up/Down buttons to move the cursor to Heat, and press Enter to set the optional heater to ON or OFF. The

default setting is OFF.

2. Use Up/Down buttons to move the cursor to Hum, and press Enter to set the optional humidifier to ON or OFF. The

default setting is OFF.

3. Use Up/Down buttons to move the cursor to NewFlow, and press Enter to set the new flow to ON or OFF. The

default setting is OFF.

4. Use Up/Down buttons to move the cursor to Standby, and press Enter to display the Standby sub-menu, as shown

in Figure 5-29.