Technical data

16 Chapter 5 Microprocessor Control
DataMate 3000 Series Air Conditioner Technical Manual
F a n
O
N
C o o l
O
N
H e a t
O
FF
L o Sp d /
D
e h u m
O
FF
Hu
m
O
FF
Ho s
T
O
FF
Sp a re
O
FF
Sy s t e
m
No r
m
H i Pr e s s N or m
Lo Pr e s s N orm
Sho r t Cy c l e N or m
Un i t N orm
Figure 5-20 Output Status screen
5.8.4 Run Time
Run Time screen displays the total operation hours of the system. Press Up/Down buttons to scroll the items, as
shown in Figure 5-21.
F a n 8 0 0 h
C o o l 2 0 0 h
H e a t 2 0 0 h
H u m 2 0 0 h
New Flow
100h
Figure 5-21 Run Time screen
5.8.5 Comp Run Record
Comp Run Record screen displays the total run record of the compressor. Press Up/Down buttons to scroll the items,
as shown in Figure 5-22.
Run Record:
Start Time:
2004/ 01/ 01
1/4
00:00
Figure 5-22 Comp run record screen
5.9 System Menu
Select System Menu from the main menu and press Enter to display the items listed in Figure 5-23.
Setup System
Select Options
Sensor Calibrate
Diagnostics
Change Password
Factory Reset N
Figure 5-23 System Menu
5.9.1 Setup System
System settings will not be lost when power fails. Select Setup System from the System Menu to display the items
listed in Figure 5-24.
M o n i t o r
T e a m wo r k
S t a r t D e l a y
C / F D eg r e e s
℃
Hum C o n t r o l RE L
Be e p e r ON
Ba c k l i g h t ON
Co n t r a s t 3 0%
L o w F a n S p e e d OFF
Temp C o m p s e n OFF
Figure 5-24 Setup System sub-menu
Use Up/Down buttons to move the cursor to Monitor as shown in Figure 5-23, and press Enter to display the sub-menu,
as shown in Figure 5-25. Press Enter to set the system address for communicating with a host. The setting range is
1~244 and the default value is 1.
U n i t N o 1
Figure 5-25 Monitor sub-menu