Specifications
Reference Manual
MHM-97408, Rev. 2
June 2008
CSI 9420
4-2
Local Display -- CSI 9420 2.4 GHz
If the LCD is installed and enabled, the LCD should display the measured
values at the configured update rate during normal operation. Every time the
device (CSI 9420) wakes up to make a measurement it dispalys these
screens and then takes a measurement. Press the Diagnostic (DIAG) button
to display the TAG, Device ID, Network ID, Network Join Status and Device
Status screens and make a measurement. For information on LCD screen
messages, see LCD Screen Messages, 2.4 GHz on page 5-2.
NOTE:
To access the DIAG button, remove the front cover of the CSI 9420.
Figure 4-1. 2.4 GHz Network Status Screens
Local Display -- CSI 9420 900 MHz
If the LCD is installed and enabled, the LCD should display the measured
values at the configured update rate during normal operation. Every time the
device (CSI 9420) wakes up to make a measurement it dispalys these
screens and then takes a measurement. Press the Diagnostic (DIAG) button
to display the TAG, Device ID, Network ID, Network Join Status and Device
Status screens and make a measurement. For information on LCD screen
messages, see LCD Screen Messages, 900 MHz on page 5-8.
NOTE:
To access the DIAG button, remove the front cover of the CSI 9420.
Figure 4-2. 900 MHz Network Status Screens
375 Field Communicator
For HART Wireless transmitter communication, a CSI 9420 DD is required.
The DD is included on the CD that was shipped with the device. The latest DD
is also available at http://www.compsys.com/drknow/swupdts.nsf. Refer to the
375 Users’ Manual for details on DD’s or go to
www.fieldcommunicator.com/syssoftdds.htm for instructions on adding a DD
for the CSI 9420 or other new devices.
Searching for
Network
Joining Network Connected Operational and ready
to send data
Searching for
Network
Joining Network Connected with
1 Parent
Connected with
2Parents