Specifications

Reference Manual
MHM-97408, Rev. 2
June 2008
2-14
CSI 9420
Select the tab of the variable you wish to configure. Enter the new values for
Advise, Maint, or Fail thresholds. If you want to suppress the alarm that is
reported when a variable exceeds a particular limit you may un-check the
associated check box. Select the "Apply" button to save the changes to the
device.
NOTE:
You may reset the alarm limits to default values by selecting the "Defaults"
button.
REMOVE POWER
MODULE
After the sensor and network have been configured, disconnect the
communication leads, remove the power module pack (if the device is not
already installed) and replace the transmitter cover. The power module pack
should be inserted only when the device is ready to be commissioned.