Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
3-44 I/O Modules Revised Jun-2013
Figure 3-26. Isolated DI/O Module Wiring (Local Termination)
Software Configuration
To use data from an Isolated Digital Input/Output module you must
add a CWM_MD board in ControlWave Designer’s I/O Configurator,
and then configure it. See the ControlWave Designer Programmer's
Handbook (D5125) for more information. That same manual includes
an I/O Mapping section that describes, for advanced users, the I/O map
for this module.