Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
Revised Jun-2013 I/O Modules 3-39
Wiring the Module
Figure 3-24 shows field wiring assignments for a locally terminated
Vac DI module.
Figure 3-24. Isolated Vac DI Module Wiring (Local Termination)
Software Configuration
To use data from an Isolated Vac Digital Input module you must add a
CWM_DI16 board in ControlWave Designer’s I/O Configurator, and
then configure it. See the ControlWave Designer Programmer's
Handbook (D5125) for more information. That same manual includes
an I/O Mapping section that describes, for advanced users, the I/O map
for this module.