Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
Revised Jun-2013 I/O Modules 3-37
Figure 3-23. MI/O Module Wiring (Remote Termination)
Software Configuration
To use data from a mixed I/O module you must add a CWM_MIX
board in ControlWave Designer’s I/O Configurator, and then configure
it. See the ControlWave Designer Programmer's Handbook (D5125)
for more information. That same manual includes an I/O Mapping
section that describes, for advanced users, the I/O map for this module.