Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
3-24 I/O Modules Revised Jun-2013
Note: Fuses F0, F2, F4, and F6 are 1/8 A.
Figure 3-14. Non-isolated HSC Module (Remote Termination)
Software Configuration
To use data from a high speed counter module you must add a
CWM_HSC4 board in ControlWave Designer’s I/O Configurator, and
then configure it. See the ControlWave Designer Programmer's
Handbook (D5125) for more information. That same manual includes
an I/O Mapping section that describes, for advanced users, the I/O map
for this module.