Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
Revised Jun-2013 I/O Modules 3-21
3.7 Non-isolated High Speed Counter (HSC) Input Module
Non-isolated High Speed Counter (HSC) Input modules provide up to
four inputs. You can individually configure HSC module inputs for
either a 10 KHz (high speed) or 300 Hz (low speed) input, and as a 16-
bit high speed counter
HSC modules consist of a HSC PCB with two 10-point terminal block
assemblies (for local termination) or two 14-pin mass termination
headers (for remote termination), 14 configuration jumpers, an LED
daughter board with four status LEDs (one for each point), and a cover
assembly. The HSC PCM connects with the backplane using a 36-pin
gold-plated card-edge connector.
Table 3-14. High Speed Counter Module General Characteristics
Type Number
Supported
Characteristics
High Speed
Counter Inputs
(HSC)
4
Each HSC supports/includes:
 Jumper to configure point as either a
low speed input (300 Hz) or a high
speed input (10 KHz).
 Jumper to configure HSC current.
 Bandwidth limiting
 Surge suppression
 Field inputs can be driven by signals or
relay contacts.
 LED status indicator
Detailed Technical
Specifications
For detailed technical specifications, please see our website
http://www.emersonprocess.com/remote.
Configurations
The non-isolated HSC module (general part number 396570-XX-X)
has the following configurations:
Table 3-15. High Speed Counter Module Configurations
Part Number Termination Connector Notes
396570-05-4:
local
396570-06-2:
remote
Setting Jumpers
HSC modules support up to four HSC inputs. Configure the HSC
jumpers (W1 through W14) according to Table 3-16.
Table 3-16. Jumper Assignments: Non-isolated HSC Module
Jumper Purpose Description
W1 – W4 Configures HSC1 through
HSC4 (respectively)
Pins 1-2 installed = Enables 300 Hz (low speed input)
Pins 2-3 installed = Enables 10 KHz (high speed input)