Instruction manual

ManualsBrandsEmerson ManualsConsumer electronicsControlWave MICRO

ControlWave Micro Instruction Manual (CI-ControlWave Micro)

3-18 I/O Modules Revised Jun-2013

Table 3-11. Non-Isolated AI/O Module Configurations

Part Number Termination

Connector

Notes

396568-01-7:

local

396568-02-5:

remote

Each non-isolated AI module (general part number 396569-XX-X)

consists of a PCB with six AIs and comes with a module cover. There

are two configurations:

Table 3-12. Non-Isolated AI Module Configurations

Part Number Termination Connector Notes

396569-01-3:

local

396569-02-1:

remote

Cable Shields

Connect cable shields associated with AI wiring to the ControlWave

Micro’s housing ground. Multiple shield terminations require that you

supply a copper ground bus (up to a #4 AWG wire size) and connect it

to the housing’s ground lug.

This ground bus must accommodate a connection to a known good earth

ground (in lieu of a direct connection from the ground lug) and to all AI

cable shields. Shield wires should use an appropriate terminal lug.

Secure them to the copper bus using industry rugged hardware

(screw/bolt, lock washer, and nuts).

Setting Jumpers

AI/O and AI modules have jumpers you can use to configure each of

the six AIs. You can individually configure AIs for 1–5 Vdc or 4–20

mA operation. See Table 3-13.

Table 3-13. Jumper Assignments: Non-isolated AI/O and AI Module

Jumper Purpose Description

JP1-JP6 Configures AI1 through AI6

(respectively)

Pins 1-2 installed = 4-20 mA AI

Pins 2-3 installed = 1-5 V AI

JP7

AO1 Field Output Pins 1-2 installed = 4-20 mA AO

Pins 2-3 installed = 1-5 V AO

JP8

AO2 Field Output Pins 1-2 installed = 4-20 mA AO

Pins 2-3 installed = 1-5 V AO

JP9

AO1 Calibration Test Pins 1-2 installed = 1-5 V AO

Pins 2-3 installed = 4-20 mA AO

JP10

AO2 Calibration Test Pins 1-2 installed = 1-5 V AO

Pins 2-3 installed = 4-20 mA AO

JP1 Configures ISP Connector

Reserved for factory use only

W1 Programs Serial EEPROM

Reserved for factory use only

1 Configuration for JP7 and JP9 must match (that is, both 1-5 V or 4-20mA)

Configuration for JP8 and JP10 must match (that is, both -5 V or 4-20mA)