Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
3-16 I/O Modules Revised Jun-2013
Figure 3-10. Non-isolated DI/O Module (Remote Termination)
Software Configuration
To use data from a non-isolated DI/O module you must add a
CWM_MD board in ControlWave Designer’s I/O Configurator, and
then configure it. See the ControlWave Designer Programmer's
Handbook (D5125) for more information. That same manual includes
an I/O Mapping section that describes, for advanced users, the I/O map
for this module.