Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
3-14 I/O Modules Revised Jun-2013
3.5 Non-isolated Digital Input/Output (DI/O) Module
Non-isolated DI/O modules consist of a digital input/output PCB with
either two 10-point terminal block assemblies (for local termination) or
two 14-pin mass termination headers (for remote termination). The
DI/O module also includes 14 configuration jumpers, an LED board
with 16 status LEDs (one for each point), and a cover assembly. The
DI/O module connects with the backplane using a 36-pin gold-plated
card-edge connector.
Non-isolated DI/O modules contain field interface circuitry for up to 12
digital inputs and four digital outputs.
Table 3-7. Non-Isolated DI/DO Module General Characteristics
Type Number
Supported
Characteristics
Digital Inputs (DI)
12
Each DI supports/ includes:
 Internally sourced DI operation for dry
contacts pulled internally to 3.3Vdc
when field input is open.
 Surge suppressor
 Signal conditioning
 Filter time of 15 ms
 Jumper to configure source current for
either 2 mA or 60 uA
 Dedicated LED on module turns ON
when DI is ON.
Digital Outputs
(DO)
4
Each DO supports/ includes:
 Open drain MOSFET provides 100mA
at 30Vdc to an externally powered
device.
 Surge suppressor
 Current sink to ground of DI/DO
module
 Dedicated LED on module turns ON
when DO is ON.
Detailed Technical
Specifications
For detailed technical specifications, please see our website
http://www.emersonprocess.com/remote.
Configurations
The non-isolated DI/O module (general part number 396567-XX-X)
comes in several different configurations. See Table 3-8.
Table 3-8. Non-Isolated DI/O Module Configurations
Part Number Termination Connector Notes
396567-02-9
local Includes LED
daughterboard.