Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
2-38 Installation Revised Jun-2013
Both keypads use the same 4-line by 20-character LCD displays. You
connect the keypad to the ControlWave Micro using a cable, one end of
which has an RJ-45 jack (connected into the RJ-45 equipped with two
plugs. This cable connects between the RJ-45 display jack (J1) on the
PSSM Board and RJ-45 jack (J1) on the remote Display/Keypad
assembly. A potentiometer, provided on the keypad, allows you to set
the contrast of the LCD display.
Note: For further information on the installation and use of the
optional keypads, refer to the ControlWave Display/Keypad
Manual (D5135).