Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
2-32 Installation Revised Jun-2013
SW1
Comm. Port 6/10
RS-485 Network
Configuration
T1
T2
Isolation
Transformers
for
Isolated RS-485
SW2
Comm. Port 7/11
RS-485 Network
Configuration
O
N
1
23
4
5678
O
N
1
23
4
56
7
8
1-2 Installed = LEDs Enabled
2-3 installed = LEDs Disabled
W1
W1
1
W2 for Comm. Port 4/8
1
W3 for Comm. Port 5/9
1
P1
2
1-2 Installed = Loopback Disabled
2-3 installed = RTS/CTS Loopback
W2
&
W3
- for Factory Use ONLY
J2
If In Slot #3 - Comm. Port Assignments = 4, 5, 6 & 7
If in Slot #4 - Comm. Port Assi
g
nments = 8, 9, 10 & 11
Comm. Port 4/8
T
ransm
i
t
LED
s
Re c e i v e LEDs
Comm. Port 4/8
RS- 2 3 2
Comm. Port 5/9
RS- 2 3 2
Comm. Port /10
RS-485
6
Comm. Port /11
RS-485
7
J4
CR1
J5
CR2
J6
CR3
J7
CR4
Comm. Port 5/9
Comm. Port 6/10
Comm. Port 7/11
Figure 2-24. Type 2 ECOM with Two RS-232 and Two RS-485 Ports
Detailed Technical
Specifications
For detailed technical specifications, please see document
CWMICRO:COM available on our website
http://www.emersonprocess.com/remote/D301673X012.pdf.
2.5.1 RS-232 Ports
Type 1 ECOMs include one RS-232 port. Type 2 ECOMs include two
RS-232 ports. For information on connecting to these ports, including
cabling information, see Section 2.4.3.
2.5.2 RS-485 Ports
Type 1 ECOMs include one RS-485 port. Type 2 ECOMs include two
RS-485 ports. For information on connecting to these ports, including
cabling information, see Section 2.4.4.