Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
2-26 Installation Revised Jun-2013
(Looking into Connector Intf. Side of P1)
Pin 1 (Wht/Grn Stripe) to Pin 1 = DCD
Pin 2 (Wht/Blu Stripe) to Pin 6 = DSR/RX+
Pin 3 (Blu/Wht Stripe) to Pin 2 = RXD/RX-
Pin 4 (Grn/Wht Stripe) to Pin 7 = RTS
Pin 5 (Wht/Org Stripe) to Pin 3 = TXD/TX-
Pin 6 (Wht/Brn Stripe) to Pin 8 = CTS
Pin 7 (Orn/Wht Stripe) to Pin 4 = DTR/TX+
Pin 8 (Brn/Wht Stripe) to Pin 5 = GND
P1
8-Pin
RJ45
Plug
9-Pin Male
“D” Connector
P2
CW
(COM3)
or
CWEXP
(COM5/6)
(
Lookin
g
into Wire Terminal Side of P2
)
Figure 2-19. Full-duplex and Half-duplex Cable
RS-232 Cable
Guidelines
Observe the following guidelines when constructing RS-232
communication cables:
 Ensure that DCD is high to transmit (except when dialing a modem)
 Verify that each RS-232 transceiver has one active receiver while
disabled (in power down mode); connect the DCD signal to the
active receiver.
 Set CTS to high to transmit.
 If the port is set for full-duplex operation, RTS is always ON.
 Ensure that DTR is always high when port is active; DTR enables
RS-232 transceivers.
Note: Control DTR using the PORTCONTROL function block and
the _Pn_AUTO_DTR system variable in your ControlWave
project. If you turn DTR off through these mechanisms, the
port remains off, even though hardware is fully configured.
 When port is set for half-duplex operation, CTS must go low after
RTS goes low.
 All RS-232 comm ports support RTS, DTR, CTS, DCD, and DSR
control signals.
 All RS-232 comm port I/O signals are protected by surge protectors.
2.4.4 Connections to RS-485 Serial Port(s) on CPU or ECOM
Modules
The RS-485 port supports local network communications to multiple
nodes up to 4000 feet away.
Your CPU module includes one RS-485 port.
If you require additional RS-485 ports, you can purchase an optional
expansion communication module that includes one or two RS-485
ports. The ControlWave Micro can support up to two expansion
communication modules, for a total of up to four additional RS-485
ports beyond the one on the CPU module. Expansion communication
modules reside in slot #3 and slot #4.
RS-485 COM
Port Names and
Connectors
RS-485 COM ports are assigned names based on their location in the
ControlWave Micro.