Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
2-10 Installation Revised Jun-2013
2.3 Power Supply/Sequencer Module (PSSM)
Before we actually configure the PSSM and install it in the housing,
we’re going to discuss some general information about how it works.
2.3.1 General Information about the PSSM
The Power Supply/Sequencer module (PSSM) plugs into slot #1 (first
slot from the left) on the ControlWave Micro’s backplane using
connector P1, a 44-pin female non-keyed header (see Figure 2-2, Figure
2-3 and Figure 2-4).
Currently, we offer the PSSM in two configurations:
 PSSM with Run/Remote/Local Switch & Display Interface (model
396657-01-0, Revision A and above) (see Figure 2-9)
 PSSM with Mode Switch SW1 & Display Interface (model 396657-
02-8 without Watch Dog, Revision A and above) (see Figure 2-10)
Note: In addition to these two PSSM versions, you can optionally
substitute a System Controller Module (SCM) for the PSSM.
Since the SCM is designed primarily for use in ControlWave
EFM models, we won’t discuss the SCM in this manual. See CI-
ControlWave EFM for more information on the SCM.
Figure 2-9. PSSM with Run/Remote/Local Switch, Display Interface, and Watchdog Connector