Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
Revised Jun-2013 Modem Installation D-3
3. Mount the MultiTech Modem to the ECOM Module making sure
that the interface connectors (J6, J7, J9 & J10 on the ECOM
Module) align.
4. Plug the antenna cable(s) (if present - removed in Step 2) into the
appropriate RF connector of an installed radio module(s).
5. Snap the cover panel onto the ECOM Module PCB and insert the
ECOM Module into the appropriate backplane slot, i.e., Slot 3 or 4.
6. Apply power and test the unit.
D2.1.2 Configuring the MultiTech Modem (MT9234SMI)
To configure a model MT9234SMI Modem (installed on an ECOM
Module), perform the following steps:
1. If required, remove the ECOM Module from the controller (see
Figure D1).
2. Place the modem into configuration mode by setting ECOM
Module jumper JP2 onto pins 2 and 3. This enables
configuration of the modem through Comm. Port 4 for modem
on ECOM1 or through COMM. Port 8 for modem on ECOM2.
3. Connect a full duplex ControlWave null modem cable (see
Figure D3) between a PC and Comm. Port 4 (ECOM1) to
configure modem on ECOM1 or Comm. Port 8 (ECOM2) to
configure modem on ECOM2.
(Looking into
Wire Terminal Side
of
Cable Connectors)
3 = TXD
6 = DSR
7 = RTS
8 = CTS
4 = DTR
2 = RXD
1 = DCD
5 = GND
To P2 Pin-4
To P2 Pin-2
To P2 Pin-7
To P2 Pin-3
To P2 Pin-6
To P2 Pin-5
To P2 Pin-1
PC
9-Pin Female
“D” Connector
P1
C
W u
/C
W EFM
9-Pin Female
“D” Connector
P2
3 = TXD
6 = DSR
7 = RTS
8 = CTS
4 = DTR
2 = RXD
1 = DCD
5 = GND
or
vice
versa
Figure D2. Internal Modem Configuration P/N 392843-01-3 Full-duplex Null Modem
Cable Diagram
4. Open HyperTerminal on the PC and set the PC communication
port settings as follows: