Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
5-16 Service & Troubleshooting Revised Jun-2013
Figure 5-10. Status LEDs on HIB
Note: To conserve power, you can disable the status LEDs by placing
jumper W5 in position 2-3.
5.3.2 Checking Wiring/Signals
Check I/O field wiring at the terminal blocks and at the field device.
Inspect the wiring for continuity, shorts, and opens. Check I/O signals at
their respective terminal blocks (see Table 5-4).
Table 5-4. I/O Field Wiring - Terminal Block Reference
I/O Subsystem Notes
Isolated Digital Inputs See Section 3.3
Isolated Digital Outputs See Section 3.4
Non-isolated Digital I/Os See Section 3.5
Non-isolated Analog I/Os See Section 3.6
Non-isolated HSC Inputs See Section 3.7
Isolated Analog Inputs See Section 3.8
Isolated Analog Outputs See Section 3.9
Non-isolated Mixed I/Os See Section 3.10
Isolated Digital Inputs (Vac) See Section 3.11
Isolated Digital Outputs (Vac/dc) See Section 3.12
Isolated Digital I/Os See Section 3.13
Isolated RTD Inputs See Section 3.14
Isolated Low Level Analog Inputs See Section 3.15
HART/BTI Input See Section 3.16
Watchdog Circuit See Section 2.3.7