Instruction manual

ControlWave Micro Instruction Manual (CI-ControlWave Micro)
Revised Jun-2013 I/O Modules 3-61
3.17 IEC62591 Interface Module
The IEC62591 interface module allows your ControlWave Micro to
communicate to a network of IEC62591WirelessHART™ field devices
such as transmitters. Once you install the module and configure the
associated ControlWave project using ControlWave Designer (available
in OpenEnterprise™ Field Tools), you connect it to a Smart Wireless
Field Link so it can access the wireless network.
The IEC62591 interface module assembly consists of two printed circuit
boards; a carrier board that fits into an I/O slot in the ControlWave
backplane, and an interface board that sits on the carrier board.
When configured and activated, the system performs an auto-discovery
of wireless devices in the network, and then collects data from them into
structures within your ControlWave project.
Notes:
 Your controller can only have one (1) IEC62591 interface module.
 Due to mechanical restrictions, you cannot install the IEC 62591
module in the last slot of any housing.
 The IEC62591 interface module is not compatible with the
ControlWave Micro I/O expansion rack.
 Each field device that will be part of the wireless network must be
individually configured with a unique long tag name, and a common
network ID and common join key used for the network. Use either
the HART Device Configurator tool in OpenEnterprise™ Field
Tools software or use an Emerson 375/475 hand-held Field
Communicator to perform this configuration. For information on
Field Tools software, see the OpenEnterprise™ Field Tools
Installation and Licensing Manual (D5141).
 The module is factory-configured for optimal performance. No
changes to DIP switches are required.
Detailed Technical
Specifications
For detailed technical specifications, please see our website
http://www.emersonprocess.com/remote.